【Tutorial & Setting up】Bitcoin Miner Antminer U3 63GH Asic Miner 63GH Btc Miner Better Than New Rbox

{UPDATE}

• This blog had moved to our official site: WWW.EASTSHORE.XYZ

Check our official site for the newest bitcoin miner, the most updated tutorial and amazing support! :-)

{Before Start}

• Please prepare a power cord for the miner.

{Miner Connection}

• Check out all the stuff in the package.

• Connect the PSU to the miner. 

• Connect the PSU to the socket on the wall via the power cord you bought in your local market.

• Connect the miner to the USB port of your PC via the data cord.

• Connection done.

{MINING GUIDE}

• Please download the driver: http://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
  
• Set up the driver “CP210x_VCP_Windows”(For 32bit OS, please install “CP210xVCPInstaller_x86.exe”; for 64bit OS, please install “CP210xVCPInstaller_x64.exe”).
• Download the software package needed (It’s a .zip file, please click “file → download” to download it): https://drive.google.com/file/d/0B-_jcpU1s5dgNEZlTjdQRi1OOTA/view?usp=sharing
  
• Connect all the cables needed. After you connected the PSU, the fan of the miner should be working.
• Connect the miner to the USB port of your PC.
• If your PC shows up “setting up the driver”, please wait it to finish.
• Run the zadig_v2.0.1.exe in the software package you download.
• Choose "Options--->List all drivers", and then in the pull-down list (as shown in Picture 1(see below)), there are one "CP2102 USB to UART Bridge Controller", choose it and click "Replace Driver".

• After the replace work done, please close zadig.
• Pull out the USB cord of the miner and please power off the miner.
• Then Power on the miner again.
• Connect the miner to the USB port of your PC via data cord again, and please note: insert in the same usb port as before.
• Run the “autorun.bat”. (You should change the mining setting to yours first, use notepad open it and modify it)
• Then it should be working, like the picture showing: